User Manual

NN-XT SAMPLER
(RECORD+REASON)
663
3. Drag the handle left/right.
Dotted lines extend from the edges of the zones up to the keyboard area. These lines give you a visual indication
of which keys the key range will encompass. There is also an alphanumerical indication at the bottom left of the
display.
4. Repeat the procedure with as many zones as you wish, to create a complete key map.
By using the Lo Key and Hi Key controls
Directly below the key map area you will find the sample parameters. These are used for changing various parame-
ters that affect how the zones are played back. They can affect single or multiple selected zones. In the middle of the
sample parameters area are two knobs called “Lo Key” and Hi Key”.
These can be used for setting the low key and the high key of a zone’s key range.
1. Make sure the zone which you want to set the key range for is selected.
2. Use the Lo Key/Hi Key knobs to change the key range.
Check the display right above the knobs for an indication of the key. You can also keep an eye on the lines extend-
ing from the zone edges to the keyboard area.
Setting key ranges for multiple zones
You can set key ranges for multiple selected zones simultaneously. This can only be done by using the Lo and Hi Key
controls. It works as follows:
Clicking and dragging the high key boundary handle of a zone with the default key range of C1 - C6...
...to change the key range to C1 - C2.