User Manual

RV7000 ADVANCED REVERB
802
• You can also set Edit Select to “Repeat Tap” - this is where you specify the repeat time for the whole multi tap
“package”.
With short Repeat times, the first tap may be repeated before the last tap has sounded. This can be used to create
very complex multiple delay effects.
The common parameters (to the left) are:
When Tap 1 - 4 is selected with the Edit Select parameter, you can make the following settings for the selected delay
tap:
When Repeat Tap is selected with the Edit Select parameter, there is only one parameter to the right in the display:
|
Parameter
|
Description
Tempo Sync Determines whether the delay times and repeat times should be freely set (“off”) or synchronized to
Record’s tempo (“on”).
Diffusion Raising the Diffusion setting will introduce additional echoes very close to the “main” repeats, caus-
ing a “smeared” delay sound.
LF Damp Controls how quickly the low frequencies should decay in the echoes. Raise it to gradually remove
low frequencies.
|
Parameter
|
Description
Tap delay Sets the delay - the time from the source signal to the tap.
When Tempo Sync is off, the delay time is set in milliseconds (10 - 2000 ms); when Tempo Sync
is on you set the delay as a number of 1/16 notes or 1/8 triplet notes, in relation to the current
song tempo.
Tap level Adjusts the level of the selected tap.
Tap pan Adjusts the pan of the selected tap.
|
Parameter
|
Description
Repeat Time Sets the time between each repeat of the whole multi tap set. The number of repeats is set with the
Decay control on the main panel.
When Tempo Sync is off, the repeat time is set in milliseconds (10 - 2000 ms); when Tempo Sync
is on you set the repeat time as a number of 1/16 notes or 1/8 triplet notes, in relation to the cur-
rent song tempo.