User Manual

HALF-RACK EFFECTS
870
The selected reverb algorithm can be tweaked using the parameters on the device panel:
CV Inputs
You can control the Decay parameter via the CV input on the back of the Reverb device.
|
Parameter
|
Description
Size Adjusts the emulated room size. Middle position (value 0) is the default size for the selected algorithm.
Lowering this parameter results in a closer and gradually more “canned” sound. Raising this parameter
results in a more spacey sound, with longer pre-delay.
For the “Stereo Echoes” and “Pan Room” algorithms, the Size parameter adjusts the delay time.
Decay This governs the length of the reverb effect. Middle position is the default decay time for the selected al-
gorithm.
Note: Decay is not used for the “Gated” algorithm.
Damp Raising the Damp value cuts off the high frequencies of the reverb, thereby creating a smoother, warmer
effect.
Dry/Wet If you are using the reverb as an insert effect, you use this parameter to adjust the balance between the
unprocessed audio signal (dry) and the effect (wet).
If the reverb is used as a send effect, this should be set all the way to wet only, since you can control the
balance by using the AUX send controls in the Mixer.