User Manual

MATRIX PATTERN SEQUENCER
(RECORD+REASON)
894
Programming “Acid Style” lead lines
By “acid style” lead lines we mean patterns that use a combination of Legato and slide (or portamento) effects to pro-
duce the widely used hypnotic “wavy” sound produced by the original Roland TB-303, and recreated in the Propeller-
head Software product ReBirth. To approximate this typical sound using Reason, proceed as follows:
1. Create a Synthesizer (Subtractor or Malström).
2. Create a Matrix Pattern Sequencer, or if one already exists, set it to an empty pattern.
3. Make sure that the Note and Gate CV outputs are connected to the synthesizers Sequencer Control CV and
Gate inputs, respectively.
4. For Subtractor, select either a Init Patch, or use the “TB Synth” patch in the Monosynth category of the Reason
Factory Sound Bank.
D If you use an Init patch, it is important that you make the following settings:
• Set Polyphony to “1”.
• Switch Trigger Mode to “Legato”.
• Set Portamento to a value around “50”.
5. Create a pattern in Matrix, and keep it playing back.
D If “Tie” (see “Using Tied Notes”) now is activated for a step, the note will be tied to the next and the pitch will
continuously “glide” to the pitch of the following step.
Please note that Tie should be activated on the note you wish to slide from, and not the note you slide to.
D If you have several tied notes, one after the other, they will play as one long legato phrase. This can be used to
create “wavy” lead lines with pitch bend effects.
6. Experiment with different Note, Tie and Gate values.
If you have ever used a TB-303 or ReBirth, you should now begin to get the hang of how you can create patterns
in that particular style by using the Matrix together with a synthesizer.
q Adding a DDL-1 (delay), and a D-11 (distortion) effect device will make it sound even more “ReBirth”-like, but
of course you are also able to get a much wider range of timbres by utilizing Reason’s other sound and modu-
lation capabilities.
Triggering samples
The Gate CV output can be used to trigger samples, either in Redrum or in the NN-19 or NN-XT Sampler.
D Connect the Matrix Gate CV out to the Gate (Sequencer Control) in on the NN-19/NN-XT or to one of the indi-
vidual Gate Channel inputs of Redrum.
Gate values will now trigger the sample on each step with Gate values above “0”.