User Manual

RPG-8 ARPEGGIATOR
(RECORD+REASON)
909
CV Outputs
The following CV outputs are available:
• Gate CV Out (Velocity) transmits a gate/velocity value that corresponds to the Velocity parameter setting.
This is normally auto-routed to the Sequencer Control Gate input on an instrument device.
• Note CV Out transmits the notes generated by the Arpeggiator (or if this is off, the notes you input to the RPG-
8).
This is normally auto-routed to the Sequencer Control CV input on an instrument device.
• Mod Wheel/Pitch Bend Outputs will normally connect to the corresponding inputs of the instrument device
controlled by RPG-8.
• The common MIDI performance controllers Aftertouch/Expression/Breath can be used to control any parame-
ters using these CV outputs.
• Start of Arpeggio Trig Out - every time the arpeggio figures start over this output will send a gate signal.
This can be used to trigger filter, amp and mod envelopes in other devices, e.g. Subtractor. The length of this gate
is the same as the length of the first note in the arpeggio.
• Sustain Pedal Gate Out - the sustain pedal can be used to trigger envelopes in other devices.
If you plug a cable into the “Sustain Pedal Gate Out” the normal pedal to the Hold parameter connection is broken
and the sustain pedal function is changed to send out a gate signal with velocity equalling the Velocity setting
knob (if Manual mode is on then velocity defaults to a value of 100).