User`s guide

2
E2050-ER1 AND RT-U43CO REMOTE CONTROLS (CONTINUED)
PROGRAMMING THE E2050-ER1 REMOTE CONTROL
This step is not essential, but allows you to use the digital terminal remote control with your TV and VCR.
How to Program the TV Mode Key
1. Turn on the TV set.
2. Point the remote control away from the digital terminal, the TV and the VCR.
3. On your remote control, press and hold TV and SELECT at the same time until the LED on the remote blinks twice.
4. Using the remote control keypad, enter your TV’s 3-digit setup code (the codes are listed in the appendix on page
68); the LED should blink once each time you enter a digit. When the three digits have been entered correctly, the LED
blinks twice. If it doesn’t blink twice, try another code.
5. Once you have found the correct code, point the remote control at the TV set and press POWER.
6. If the TV turns off, write the code you used here: TV ________________
7. If your TV or VCR brand is not listed in the appendix or if none of the codes works, refer to "How to Search for
Codes", below.
How to Program the VCR Mode Key
1. Turn on the VCR and move the VCR/VOD slide switch to the VCR position.
2. Repeat the steps described under "How to Program the TV Mode Key", substituting the VCR key for the TV key.
3. Write the code you used here: VCR ________________
How to Search for Codes
1. Point the remote control away from your TV or VCR, depending on which one you are programming.
2. To search for TV codes, press and hold TV and SELECT at the same time until the LED on the remote blinks twice.
or
To search for VCR codes, press and hold VCR and SELECT at the same time until the LED on the remote blinks twice.
3. Slowly enter the code 9 9 1; the LED should blink once each time you enter a digit. When the three digits have been
entered correctly, the LED blinks twice.
4. Point the remote control at the TV or VCR, and press TV or VCR.
If the device turns off, go to step 5.
If the device remains on, start again from the beginning of step 4.
5. Press SELECT to confirm a valid code; the LED blinks twice.
6. Point the remote toward the device you programmed, and power on and off to confirm operation.
7. You now need to identify the code you just found.
Located in the bottom right corner of the remote, the VCR/VOD key is used to activate the dedicated
Video-on-Demand and VCR keys.
• Slide it to the VOD position when using Video-on-Demand, and to the VCR position when using the VCR.