Jnl) Hl ta llano | En |__ME CLUE |W") User Manual Proscenium Technology Co., Ltd. E-mail: Web: www.proscenic.com Pro scenic Please keep this user manual in your sight, read it thoroughly and carefully before using this product.
| Packing List Remote Contrition Charging base*1 Adapter*1 TST I 7 STAT TATE LEAK Li Disposable mopping cloth*10 ne Side Brush* 2 HEAP filter*1 Manual*1 Water tank*1
| Product description Host (1) Start/Stop Button Extended press to tum on /Short press to tum off Start/pause cleaning ¢ Recharge button Short press to start/pause recharging Solid blue light: Normal working/pause/standby Blue light flash: Is powering on/configuring network/upgrading firmware Yellow light flash: low battery/recharging Green light flash: charging Solid green light: Fully charged Red light flash quickly: Abnormal/Error Light off: Off/sleep Network Configuration While the power, Is on, press a
| Product description Host and sensor Laser ranging sensor Button Speaker Infrared recharge/an— Tl-collislon sensor sensor Wall-mounted TOF sensor / infrared auxiliary recharge sensor Anti-collision sensor Laser head cover pressure sensor Infrared auxiliary recharge sensor Alr outlet Dust box release button Dust box
| Product description Host and sensor Right side brush Right drive whee! Rolling-Brush Charging base Indicator light Signal emitting area Charging pols piece Front of the Charging baas Charging pole piece Universal wheel Left side brush Cliff sensor Left drive whee! Middle sweep cover The back of the Charging base
| Product description Dust box assembly Dust box release button Dust box buckle Dust box Filter mesh bracket HEAP fitter CS *Interspersion S Dust box flip —— Primary filter = Dust box release button water tank Water Inlet Mop cloth Liter of water tank
| Installation Notes Installing the charging base Connect the power cord and the charging base is placed against a wall on a flat surface. Against the wall Not against the wall * Make sure that there Is more than 1.2 meters In front of the charging base and more than 0.5 meters In the left and right sides to ensure a smooth back fill. * Do not place the cradle In direct sunlight.
| Instructions for use Power on/off Press and hold the “ {1} * button to power on, and the host enters the standby state. After booting, press and hold the “0 ” button to shut down. Note: When the host is charging on the charging stand, it will automatically tum on, and it cannot be muted off during charging. Start/pause Under the power on state, short press the button to start the whole house cleaning. Press any key to pause while cleaning.
I Instructions for use Connect to the mobile client @ The phone Is connected to WIFI; @ Scan the QR code below, or search for “Proscenium” — In the mobile app store to download the app, register omy | Comer) and login to the account; Pe Tha soon @ Add device on the home page choose @ Press and hold the and keys for 5 seconds to sweeping robot PRO"; enter the network configuration; ® Select the connected WIFI of the phone @® Go to the mobile phone ELAN list and select and connect and enter the WIFI password;
I Instructions for use Remote control Recharge button Arrow key Start/Pause button Mopping mode Spot cleaning Mute button Ear reduction Gear plus Max button Note: 1. To ensure remote control effectively, It Is recommended to use It In the front area of the host; 2. The effective distance of the remote control Is 8 meters.
| Instructions for use Water tank If you need to mop the floor, you can use the water tank. Note: Do not mop the floor on the carpet to avoid wet carpet. @ Wet the mop with water, attach the mop cloth to the Velcro and tighten it, fill In the water through the water inlet, and close the rubber cover; the app.
| Routine maintenance Dust box and filter assembly (recommended weekly) @ Press the dust box rel sass button to remove @ Open the dust box, and dump out the garbage; the dust box; @ Open the dust cover and remove the filter @ Shake off the trash on the filter net and use a cleaning brush such as HEAP and sponge; to clean the dust box and filter; 1
I Routine maintenance ® After filing clean water Into the dust box, shut off the ® After drying the filter and dust box, replace the filter dust box and shake It to the left end right, and pour out and dust box. the dirty water.
| Routine maintenance @ Pour out the remaining water In the water tank @ After the rag and water tank are dry, put It back and dry the water tank; for uss; ® Filter of Water tank If #he amount of water is small or doses not produce water, it is recommended to replace the tank filter. @. Pull out two old fitters; @. Press the new filter element down firmly until It Is fastened.
| Routine maintenance Main brush (recommended weekly) (D Turn the main unk, press the left and right buckles, and remove the middies sweep cover; @ Remove the roller brush upwards and clean the entangled hale and rubbish with a cleaning brush; @ Replace the roller brush and Insert the three legs of the midis sweep cover Ina the slat, press down and fix the buckle. Note: Depending on the application, It Is recommended ta replace the man brush for 6-12 months to ensure the cleaning effect.
| Routine maintenance Side brush (recommended weekly) @ Use a screwdriver to unscrew the 2 side brush screws and remove the 2 side brushes; @ After cleaning the wrap hale and rubbish on the side brush, replace the side brush. Note: Depending on the application, It Is recommended to replace the side brush for 3-6 months to ensure the cleaning effect.
| Routine maintenance Host and sensor (recommended monthly) Wipe the sensor on the main unit with a soft, dry cloth, including: @ 4 cliff sensors at the bottom of the main unit @ Wall sensor on the right side of the host @ Infrared auxiliary recharge sensor @ Charging pole at the bottom of the main unit —e Charging pole pace Wall-mounted TOF sensor / Infrared dilatory recharge sensor Infrared auxiliary recharge sensor 16
I Routine maintenance Charging base (recommended monthly) Universal wheel Wipe the charging pole of the charging base (recommended monthly cleaning) with a soft, dry cloth. @ Flip the main unit and pull out the universal wheel upwards; @ Clean the hair and dust on the wheel, axle and support; @ Reinstall the universal wheel and press it tight. Note: Wash with water, dry it and put it back.
Basic parameters Host Charging base Name Parameters Dimension 145mnroc1 40mmxaSmm Dimensions $350mmx$350mmx38mm Rated power 30W Product weight =3.6kg Rated Input 24V == 12A Rated voltage 14.4v= Rated output Rated power 50W Battery capacity 5200mAh Troubleshooting Fault prompt Solution Abnormal 1. Please confirm that the laser radar is not blocked Please check or remove forsworn objects around the liar or move the device to a new location to restart Abnormal 2.
| Common problem Question type Solution The battery Is low, please charge It before using It Can not boot Ambulant temperature Is too low (less than 0°C) or too high (higher than 50°C) Unable to start cleaning The battery is low, please charge it before starting it Unable to recharge There aro too many obstacles near the charging stand. Please put tho charging stand In open area The host Is tog far from the recharge seat.
| Security Information Use limit + This product is only used for floor cleaning in the home environment. Do not use it outdoors {such as open balconies), non— ground {such as sofas), commercial or Industrial environments, such as non-ground (such as sofas), commercial or Industrial environments. Do not use in environments where there is liquid or viscous material above 40°C, below 0°C. Do not use or operate this product for people with physical, mental or cognitive Impairments, Including children.
| FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions: {1) This device may not cause harmful Interference, and {2) This device must accept any Interference raveled, Including Interference that may cause undesired operation. 2. Chang's or modifications not expressly approved by the party responsible for compliance could cold the user's authority to operate the equipment.
