Instructions / Assembly

6345 Nancy Ridge Drive, San Diego, CA 92121
[phone] ● [phone] ● Fax [phone] ● Email: [e-mail]
ProSeal
™
U-shaped Garage Door Bottom Seal
Installation Instructions
1. Remove existing garage door bottom seal. Some garage door
manufacturers will pinch the aluminum track to hold the bottom seal in
place. To open a pinched track, insert a flathead screw driver, into the end
of the track, and gently pry open the end, just enough to allow removal of
the old door seal. Both ends of the track may need to be opened.
2. Make sure any debris in the track has been removed and that it is clean
and dry. Straighten out any cramps in the track.
Quick Tip: Mix a bucket of water with some liquid dish soap or liquid
laundry detergent. Place the seal in the soapy water and pull it out as you
install it into the track.
3. Starting at either end of the garage door, insert the ¼” T-ends, attached to
the ProSeal
™
Garage Door Bottom Seal, into the track. Next, slide the
ProSeal
™
into the track, until it reaches the opposite side. Continue to pull
the seal until you have approximately 2" protruding beyond the end of the
track.
4. Leave 2" protruding on both sides, then use scissors to trim off the excess
ProSeal
™
. If your door seal track was pinched and you wish to pinch it
back together, use pliers to gently pinch the track back into place. Now
tuck the 2" of excess seal back into the U-shaped opening. This will lock
the seal in place.