Instructions / Assembly

6345 Nancy Ridge Drive, San Diego, CA 92121
[phone] ● [phone] ● Fax [phone] ● Email: [e-mail]
36010, 36020, 56010, 56020
ProSeal
™
Bulb Seal Garage Door Bottom Seal
Installation Instructions
1. Remove existing garage door bottom seal. Some garage door manufacturers will
pinch the aluminum track to hold the bottom seal in place. To open a pinched
track, insert a flathead screw driver, into the end of the track, and gently pry open
the end, just enough to allow removal of the old door seal. Both ends of the track
may need to be opened.
2. Make sure any debris in the track has been removed and that it is clean and dry.
3. Starting at either end of the garage door, insert the T-End, attached to the
ProSeal
™
Garage Door Bottom Seal, into the track. Next, slide the ProSeal
™
into the track, until it reaches the opposite side
Quick Tip: Mix a bucket of water with some liquid dish soap or liquid
laundry detergent. Place the seal in the soapy water and pull it out as you
install it into the track.
4. Using a scissors, trim off the excess ProSeal
™
. If your door seal track was
pinched and you wish to pinch it back together, use pliers to gently pinch the
track back into place.
To ship the Bulb Seal, it has
been folded into the box.
Once installed and used
over time it will regain its
original shape.