Instructions / Assembly

6345 Nancy Ridge Drive, San Diego, CA 92121
[phone] ● [phone] ● Fax [phone] ● Email: [e-mail]
ProSeal
™
Bulb Seal Garage Door Bottom Seal
Installation Instructions
1. Remove existing garage door bottom seal. Some garage door
manufacturers will pinch the aluminum track to hold the bottom seal
in place. To open a pinched track, insert a flathead screw driver, into
the end of the track, and gently pry open the end, just enough to
allow removal of the old door seal. Both ends of the track may need
to be opened.
2. Make sure any debris in the track has been removed and that it is
clean and dry.
3. Starting at either end of the garage door, insert the T-End, attached
to the ProSeal
™
Garage Door Bottom Seal, into the track. Next, slide
the ProSeal
™
into the track, until it reaches the opposite side
Note: In order to keep the ProSeal
™
securely in place, the T-End
has been manufactured slightly oversized. To make installation
easier, apply liquid soap to the T-End.
4. Using a scissors, trim off the excess ProSeal
™
. If your door seal
track was pinched and you wish to pinch it back together, use pliers
to gently pinch the track back into place.
Made in U.S.A.
To ship the Bulb Seal, it has
been flatten and rolled into
the box. Once installed and
used over time it will regain
its original shape.