User manual

MVI56-HART ♦ ControlLogix Platform Index
HART Multi-drop Master Communication Module User Manual
ProSoft Technology, Inc. Page 169 of 171
October 13, 2011
Index
[
[HART PORT x COMMANDS] • 38
[HART PORT x] • 35
[MODULE] • 34
A
Adding the Module to an Existing Project •
57
Allocation of Risks • 168
Analyzing Data for Port 1 • 70
Application Port Connection • 102
Auto-Poll Code • 36
Auto-Poll Data (HARTAutoPoll) • 56
Auto-Poll DB Address • 37
Auto-Poll Disabled Mode • 93
Auto-Poll Modes • 89
Auto-Poll Swap Float • 37
Auto-Polling • 91
B
Backplane Data Transfer • 84
Backplane Object (HARTBackplane) • 54
Battery Life Advisory • 4
Block 9902
Command Control • 41, 86
Block 9903
Command Disable Control Block • 41, 87
Block 9950
Read Command Error List • 87
Block 9998
Warm Boot • 88
Block 9999
Cold Boot • 88
Burst Mode • 91
Byte Count • 44
C
Channel Status Object (HARTCHStat) • 53
Clearing a Fault Condition • 76
COMMAND 00 - Read Unique Identifier •
118
COMMAND 01 - Read Primary Variable •
119
COMMAND 02 - Read Current And Percent
Of Range • 120
COMMAND 03 - Read Dynamic Variables •
121
COMMAND 06 - Write Polling Address • 122
COMMAND 108 - Write Burst Mode
Command Number • 158
COMMAND 109 - Burst Mode Control • 159
COMMAND 110 - Read All Dynamic
Variables • 160
COMMAND 12 - Read Message • 123
COMMAND 13 - Read Tag, Descriptor and
Date • 124
COMMAND 14 - Read PV Sensor Info • 125
COMMAND 15 - Read Output Information •
126
COMMAND 16 - Read Final Assembly
Number • 127
COMMAND 17 - Write Message • 128
COMMAND 18 - Write Tag, Descriptor and
Date • 129
COMMAND 19 - Write Final Assembly
Number • 130
COMMAND 33 - Read Transmitter Variables
• 131
COMMAND 34 - Write Damping Value • 132
COMMAND 35 - Write Range Values • 133
COMMAND 36 - Set Upper Range Value •
134
COMMAND 37 - Set Lower Range Value •
135
COMMAND 38 - Reset Configuration
Changed Flag • 136
COMMAND 39 - EEPROM Control • 137
COMMAND 40 - Enter Exit Fixed Current
Mode • 138
COMMAND 41 - Perform Transmitter Self
Test • 139
COMMAND 42 - Perform Master Reset • 140
COMMAND 43 - Set PV Zero • 141
COMMAND 44 - Write PV Units • 142
COMMAND 45 - Trim DAC Zero • 143
COMMAND 46 - Trim DAC Gain • 144
COMMAND 47 - Write Transfer Function •
145
COMMAND 48 - Read Additional Transmitter
Status • 146
COMMAND 49 - Write PV Sensor Serial
Number • 147
COMMAND 50 - Read Dynamic Variable
Assignments • 148
COMMAND 51 - Write Dynamic Variable
Assignments • 149
COMMAND 52 - Set Transmitter Variable
Zero • 150
COMMAND 53 - Write Transmitter Variable
Units • 151
COMMAND 54 - Read Transmitter Variable
Information • 152
COMMAND 55 - Write Transmitter Variable
Damping Value • 153
COMMAND 56 - Write Transmitter Variable
Sensor Serial Number • 154
COMMAND 57 - Read Unit Tag Descriptor
Date • 155
COMMAND 58 - Write Unit Tag Descriptor
Date • 156