User manual

Configuration Commands RLXIC-SG Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
ProSoft Technology, Inc. Page 89 of 136
May 29, 2009
11 Configuration Commands
In This Chapter
Info (information) ...................................................................................89
Status ....................................................................................................91
Common................................................................................................93
Logging................................................................................................120
Telemetry/Addr List .............................................................................121
Edge/HSDPA.......................................................................................123
The configuration commands (AT commands) in this chapter are arranged
according to their placement in AceManager.
Note: Some commands can only be configured using a terminal emulation and typed AT
commands. Some commands also require PassThru mode.
Tip: You can use a fully qualified domain name instead of an IP address for most configuration
options calling for an IP address if your RLXIC-SG is configured to use DNS. DNS settings
frequently come directly from your cellular provider while your RLXIC-SG is registering on the
cellular network, and receiving its IP address.
11.1 Info (information)
The commands in the "Info" group have read-only parameters. They only provide
information about the modem. Some of the information displayed in this group
does not correspond directly to AT commands.
*DEVICEID?
The 64-bit device ID the modem uses to identify itself to the cellular network.