User manual

Configuration Commands RLXIC-SG ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
ProSoft Technology, Inc. Page 95 of 136
May 29, 2009
DS=n
Allows a PPP connection to be initiated on the host port.
 n=2 : Initiates the PPP connection.
Cannot be configured in AceManager.
Hn
Hang-Up Command.
 n=1 : Hang-up
With an AT telnet connection, this command will terminate the host data mode,
and return the RLXIC-SG to an AT mode. Cannot be accessed in AceManager.
O
Online (Remote): Causes the RLXIC-SG to go from Command State to data
state. Cannot be configured in AceManager.
OPRG=n
Enables/disables over-the-air firmware upgrading of the RLXIC-SG. When
ProSoft Technology releases a new version of ALEOS, you can upgrade your
remote modems with OPRG enabled.
 n=0 : Disables
 n=1 : Enables
S53=[method][d.d.d.d][/ppppp]
Destination IP address, port, and method. These are used as defaults for the D
(Dial) AT command.
 method= P : UDP
 method=T : TCP
 method=N : Telnet
 d.d.d.d=IP address or domain name
 ppppp=the port address
Examples:
ATS53=T192.168.100.23/12345
ATS53=foo.earlink.com
Telnet to the specified IP at port 12345.
ATS53=192.168.100.23/12345
Query the specified IP at port 12345.
ATS53=/12345
Query port 12345.