User manual

RLXIC-SG ♦ Intelligent Cellular Configuration Commands
RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM User Manual
Page 96 of 136 ProSoft Technology, Inc.
May 29, 2009
Z
Reset the RLXIC-SG. In AceManager, this command is performed with the Reset
option on the toolbar.
Tip: *DATZ=1 will disable Z.
&W
Writes all changed modem settings. If this command is not issued, any modified
values will revert back to their previous values at modem reset. Cannot be
configured in AceManager.
*DATE=[mm/dd/yyyy],[hh:mm:ss]
Sets and queries the internal clock. Either the date and time can be specified, or
simply one of the two can be specified in which case the unspecified value will
remain unchanged. The date and time are always specified 24-hour notation.
 mm/dd/yyyy=date in month/day/year notation
 hh:mm:ss=time in 24-hour notation
*DPORT=n
The modem's Device Port which the modem is listening on for inbound
packets/data/polls. Can also be set with the command S110.
 n=1-65535
*HOSTPAP=n
Use PAP to request the user login and password during PPP negotiation on the
host connection.
 n=0 : Disable PAP request (Default).
 n=1 : Takes user login and password from Windows DUN connection, and
copies to *NETUID and *NETPW.
*NETALLOWZEROIP=n
Allows the displayed IP address in *NETIP to end in zero (ex. 192.168.1.0).
 n=0 : Do not allow.
 n=1 : Allow.
*NETPW=pw
The password that is used to login to the cellular network, when required.
 pw=password (30 characters maximum)
*NETPHONE?
The modem's phone number, if applicable or obtainable.