User manual

Configuration Commands RLXIC-SG ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
ProSoft Technology, Inc. Page 97 of 136
May 29, 2009
*NETUID=uid
The login that is used to login to the cellular network, when required.
 uid=user id (up to 64 bytes)
*STATICIP=d.d.d.d
Set the static IP required to be received from the network. If the modem does not
get this IP address from the network, it will reset the internal hardware, and try
again. The default is 0.0.0.0, which allows any IP address from the network.
 d.d.d.d=IP address
Example:
AT*STATICIP=192.168.1.23
Caution: STATICIP does not set the IP address of the modem, it merely tells the modem which IP
address to expect. If the expected IP address is not granted while registering on the cellular
network, the modem will try to register on the network again until it receives that IP address. If your
account is set up for a dynamic IP address, and you set an address for *STATICIP, you may not be
able to register on the network at all because there is no guarantee you will receive the same
dynamic IP address again.
*STATUSCHK=n
Checks if an SMS message has been received by the modem.
 n=1-255 : Seconds between checks.
 n=0 : Never check.
11.3.2 Serial
This group includes commands specific to general use of the serial port.