User manual

Configuration Commands RLXIC-SV ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network
ProSoft Technology, Inc. Page 109 of 146
May 29, 2009
Vn
Command Response Mode.
 n=0 : Terse (numeric) command responses
 n=1 : Verbose command responses (Default).
Xn
Extended Call Progress Result mode.
 n=0 : Turn off extended result codes (Default).
 n=1 : Turn on result codes. This adds the text 19200 to the CONNECT
response.
&Cn
Set DCD mode.
 n=0 : Always assert DCD.
 n=1 : Assert DCD when in a data mode (UDP, TCP, PPP, or SLIP) (Default).
 n=2 : Assert DCD when the modem has network coverage.
&Dn
Set DTR mode.
 n=0 : Ignore DTR, same effect as HW DTR always asserted (same as
S211=1).
 n=2 : Use hardware DTR (same as S211=0).
&Sn
Set DSR mode.
 n=0 : Always assert DSR (Default).
 n=1 : Assert DSR when in a data mode (UDP, TCP, PPP, or SLIP) (Default).
 n=2 : Assert DSR when the modem has network coverage.
Tip: S211 can also be used to request that DSR is always asserted. If S211 is set to 3, and &S is
changed to a non-zero value, S211 will be changed to 1.
\APPP
Set modem operation to PPP mode. Cannot be configured in AceManager.
\ASLIP
Set modem operation to SLIP mode. DTR must be asserted (&D0 or S211=1).
Cannot be configured in AceManager.