User manual

RLXIC-SV ♦ Intelligent Cellular Configuration Commands
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network User Manual
Page 110 of 146 ProSoft Technology, Inc.
May 29, 2009
\Qn
Set or query the serial port flow control setting.
 n=0 : No flow control is being used.
 n=1 : RTS/CTS hardware flow control is being used.
 n=4 : Transparent software flow control. Uses escaped XON and XOFF for
flow control. XON and XOFF characters in data stream are escaped with the
@ character (0x40). @ in data is sent as @@.
+FCLASS=n
This command sets the RLXIC-SVinto a particular fax-mode operation, which
causes the internal hardware to process information presented in the Dial
command in a manner suitable for that type of information. Cannot be configured
in AceManager.
 n=0 : Fax/data call.
 n=8 : Normal interconnect.
+WVCLASS? queries the current setting.
+IPR=n
I/O Port Rate: Sets the data rate for the serial port (DTE-DCE). C3x11 or C3x11E
only. Default is 115200. Cannot be configured in AceManager.
+WVLASS=n
This command sets the RLXIC-SV into a particular voice-mode operation, which
causes the internal hardware to process information presented in the Dial
command in a manner suitable for that type of information. Cannot be configured
in AceManager.
 n=0 : Normal interconnect (using line 1).
 n=9 : Fax/data call.
$QCVAD=n
Mode for answering data or fax with the A (answer) or via auto answer (S0=1).
C3x10 or C3x10E only. Cannot be configured in AceManager.
*CTSE=n
Clear To Send Enable: This feature asserts CTS when there is a network
connection.
 n=0 : Disabled (Default).
 n=1 : Enable assertion of CTS when there is network coverage.
RS232 voltage levels:
 Positive = Network coverage.
 Negative = No coverage.