User manual

RLXIC-SV ♦ Intelligent Cellular Configuration Commands
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network User Manual
Page 112 of 146 ProSoft Technology, Inc.
May 29, 2009
S0=n
This register determines how the RLXIC-SV responds to an incoming TCP
connection request. The RLXIC-SV remains in AT Command mode until a
connection request is received. DTR must be asserted (S211=1 or &D0), and the
RLXIC-SV must be set for a successful TCP connection. The RLXIC-SV will send
a "RING" string to the host. A "CONNECT" sent to the host indicates
acknowledgement of the connection request, and the TCP session is
established.
 n=0 : Off (Default).
 n=1 : On.
 n=2 : Use Telnet server mode on TCP connections.
 n=3 : With a Telnet connection, overrides the client's default echo, allowing
the server on the host port to perform the echo. CRLF sequences from the
telnet client will also be edited to simply pass CRs to the server on the host
port.
S7=n
Specifies the number of seconds to wait for a TCP connection to be established
when dialing out.
S60=n
Telnet Client Echo Mode.
 n=0 : No Echo
 n=1 : Local Echo (Default)
 n=2 : Remote Echo
S221=n
Connect Delay: Number of seconds to delay the "CONNECT' response upon
establishing a TCP connection. OR Number of tenths of seconds to delay before
outputting ENQ on the serial port after the CONNECT when the ENQ feature is
enabled
TCPS=n
TCP connection time-out (TCPS) units. Specifies a time interval upon which if
there is no in or outbound traffic through a TCP connection, the connection will
be terminated.
 n=0 : minutes
 n=1 : seconds
TCPT=n
Interval to terminate a TCP connection when no in or outbound traffic. This value
affects only the TCP connection in TCP PAD mode.