User's Manual

RLX2 Industrial Hotspot Series

Page164of208 ProSoftTechnology,Inc.
 February5,2015

BN(Brown)andWH(White)wiresaretiedtogetherandconnectedto“‐“.
PinAssignmentM12Socket,4‐pos,A‐coded,ViewFemaleSide

RadioPowerRequirements(Allotherradios)

Note:Thefollowinginstructions donotpertaintotheRLX2‐IHNF‐Wradio. 
TheRLX2radiosaccep
tvoltagesbetween10and24VDC,withanaveragepowerdraw
oflessthan8Watts.Adetachablepowerconnectorcomeswiththeradio,asshown
below.Theconnectorterminalsarelabeled+(positiveDCconnection)and‐(DCground
connection).
TheAC‐to‐DCpowersupplyadaptersuppliedwithth
eoptionalRLX‐IHBTKBenchTestKit
canbeused.TheDCpowerwiresmustbelessthan3metersinlengthtomeet
regulatoryrequirements.
Important:Whenwiringthepowerconnectorsuppliedwiththeradio,besureto
observetheproperpolaritymarkingsonthepowerconnector.Wiringtheconnector
incorrec
tlycancauseseriousdamagetotheradiowhichwillnotbecoveredunderthe
ProSoftwarranty.
