User's Manual

RLX2 Industrial Hotspot Series

ProSoftTechnology,Inc. Page33of208
February5,2015

AntennasaretobeinstalledinaccordancewithControlDrawing06/2514.Seethe
Antennasectioninthismanual.
ForAllOtherRadios


1. AttachanEthernetcabletothedesigna tedmasterRLX2radio.Makesurethis
networkconnectionisonthesamesubnetasthePCrunningtheIHBrowser
configurationsoftware.

Note: The Ethernet DATA LED should come on when data is sent or received from the radio. The
Ethernet SPEED LED indicates the speed of the Ethernet connection. The SPEED LED is off for
10 Base T, on for 100 Base T, and blinks about once every two seconds for 1000 Base T links.
Power‐UptheRadios
1. Poweruptheradio.ThereisnoOn/OffSwitch.Powerisappliedwhenthepower 
cordconnectionismadetotheRLX2radio.
ThepowerLEDshouldilluminatewithanambercolor,thengooutforafewseconds
duringinitialization,thenfinallycomebackongree
n.Thisprocesswilltake10to15
seconds.OncethepowerLEDisgreen,theradiohasbootedandisoperational.
OtherLEDsmaybecomeactiveaswell.
2. TakenoteoftheMACaddressoftheRLX2radio.Thisisprintedonalabelattached
tothefrontoftheradio.Th
eMACaddressshouldbesomethinglike00‐0D‐8D‐XX‐
YY‐ZZ(e.g.00‐0D‐8D‐F0‐5C‐8E.)Thisnumberuniquelyidentifiestheradioonthe
network.
3. RuntheIHBrowserconfigurationsoftware.
