User's Manual

RLX2 Industrial Hotspot Series

ProSoftTechnology,Inc. Page61of208
February5,2015

LED
Description
SignalStrength
BlinksifSDcardinsertedwithnewconfiguration

Thisisforallradiomodes.

RadiosinMastermode:
Noradioslinked
Oneormoreradioslinked(rightLEDblinking).
DFSChannelAvailabilityCheckinprogress(allLEDsblinkingAmber)

RadiosinRepeaterorClientmode:
NoSignal
Radiolinked,PoorSignal
Radiolinked,FairSignal

Radiolinked,GoodSignal



OncethepowercableandEthernetcableareconnectedtotheradio,thePower/Status
LEDshouldilluminategreen.TheSPEEDLEDshouldindicateavalidwiredlink.TheRF
TransmitandRFReceiveLEDsshouldstarttoblinkoccasionally.
ForRepeaterorClientmoderadios,allthreeSignalStrengthLEDswillblinkjus
tafterthe
radiolinkstotheMaster’ssignalbutbeforeithasbeenfullyauthenticated.Normally
thislastsonlyafewseconds.Ifitlastslongerorneverturnssoliditusuallymeansthe
encryptionkeysarenotcorrect.
RetrievetheDefaultPassword
Ifthepasswordisunknown,theuserwillbeunable tochang etheradiosettings.The
usercanretrievethedefaultpasswordtousethesoftwareagain,butwillloseallthe
settingsthatwereprogrammedbefore.
RLX2‐IHNF‐WandRLX2‐IHNF‐WCReset
1. Removepowerfromtheradio.
2. PresstheResetbutton.TheResetbuttonislocatedonthefrontoftheunitjust
undertheProSoftlogo.