Photo Printer User Manual

COMPACT 2
TM
17
Operation
English
®
Manual replenishment:
1. Switch to manual mode.
2. Press required replenishment button for developer (7) or fixer (8) - respective
button illuminates.
3. Start replenishment cycle by pressing arrow-button “up” (2) or cancel replen-
ishment cycle by pressing arrow-button “down” (3).
In the memory five sets of parameters can be stored and be recalled into working
memory.
Use of Memory Function
In the memory five sets of parameters can be stored and be recalled into working
memory.
Store processing parameters
1. Set machine to preferable parameters e.g. bath tem-perature, processing
time etc. (see manual).
2. Press buttons 4 and 5 “Enter Memory” simultaneously to enter the memory
mode.
3. Use buttons 2 and 3 “Select” to select the parameter memory (P1 to P5).
Inside this the parameters will be stored, old values will be overwritten.
4. Press button 5 “Store” to store parameters and to leave the memory mode.
Recall processing parameters
1. Press buttons 4 and 5 “Enter Memory” simultaneously to enter memory
mode.
2. Use buttons 2 and 3 “Select” to select the parameter memory (P1 to P5)
from which the parameters shall be recalled.
3. Press button 4 “Recall” to recall parameters (copy into working memory) and
to leave the memory mode.
To leave memory mode without change
Press button 6 “Exit”.
Important
: Please note, if input is locked (via lock function), then processing
parameters cannot be stored - when trying to do this, an error message “LO” will
be displayed. Despite locked input, the processing parameters can be recalled.
Choose the same bath temperature for all stored programmes. Of course differ-
ent bath temperatures can be stored too, but when changing the programme you
always have to wait until the changed bath temperature is reached.
Enter Memory
Power on Autofill
Recall Store
Select
Exit