Photo Printer User Manual

COMPACT 2
TM
23
Maintenance / Disposal
English
®
Recommended Maintenance Work:
1. Functional check
film intake / film transport / replenishment / bath heating / dryer heating / water supply
2. Cleaning
2.1. Switch off machine, remove cover
2.2. Empty all three tanks
2.3. Close drain cocks and fill tanks with water
2.4. Install cover, switch machine on
2.5. Fill two additional vessels with water, put suction pipes into these vessels and activate replenishment for at
least two minutes (to remove residues of chemicals from replenishing hoses)
2.6. Switch machine on for a few minutes
2.7. Switch machine off
2.8. Empty all tanks
2.9. Prepare tank cleaning agent for developer and water tank according to manufacturer´s instructions
2.10. Fill developer and water tank with tank cleaning agent (do not
use the replenishment pumps to do so)
2.11. Fill fixer tank with water
2.12. Place suction pipes into empty tanks
2.13. Install cover, switch machine on
2.14. Wait until the operating temperature is reached, approx. 30 °C (observe information concerning temperature,
time, cleaning procedure contained in the datasheet of the tank cleaning agent)
2.15. Activate manual programme and transport
2.16. After approx. 15 minutes (observe information concerning temperature, time, cleaning procedure contained in
the datasheet of the tank cleaning agent) switch film transport off
2.17. Remove cover, neutralise developer tank (observe information concerning temperature, time, cleaning proce-
dure contained in the datasheet of the tank cleaning agent)
2.18. Switch machine off
2.19. Empty all three tanks
2.20. Fill machine with water and switch it on
2.21. Put suction pipes into vessels with water
2.22. Activate replenishment pumps for at least three minutes
2.23. Check all pumps for tightness
2.24. Switch machine off
2.25. Drain tanks
2.26. Fill tanks with water until half full
2.27. Switch machine on
2.28. Activate replenishment pumps manually until tanks overflow
2.29. Activate film transport for a few minutes
2.30. Switch machine off and drain all three tanks
Attention:
Never start the machine up unless it is filled with liquid!
Attention:
Do not use chlorine containing cleaning agents!