Photo Printer User Manual

28 COMPACT 2

Problems and Solutions

Error messages

Machine errors are shown on the display as abbreviations. The cause of error is ex-

plained below. For service technician: problem solution see “Trouble shooting” in

service manual.

Display Cause and possible correction

Cover switch is not actuated. Place cover correctly on the

machine and ensure that the cover switch behind the control

panel is actuated. If the error cannot be corrected, then the

cover switch may be broken.

Motor servo-control defective, call service technician. In the

meantime work can be continued with the last set processing

speed. The processing speed cannot be altered. (Service see

“Display shows error message “E2”” on page 39).

Drive-overload, take off machine cover and remove all roller-

racks. Check each rack for easy rotation of the drive shaft. If

necessary clean roller-racks and machine. Error can be reset

by switching the machine off. If the need arises let a service

technician check the machine. If the above measures do not

improve the situation, the motor may be defective.

Error: Overtemperature in dryer section. Call your service

technician. Dryer components could be broken.

Machine can only be used in manual mode, and the dryer fan

runs continously (error will always be displayed). The

machine may only be operated under constant supervision.

Check if air is coming out from the opening in the cover. If no

air comes out, the fan is defective and the machine may not

be used. Switch the machine off.

Error can only be reset by switching the processor off (Serv-

ice see “Display shows error message “E4”” on page 41).

Input locked. To change operation parameters the lock func-

tion must be deactivated (see “Lock Function” on page 18).