Photo Printer User Manual

38 COMPACT 2
TM
Trouble Shooting
®
Trouble Shooting
Summary
1 Algae ............................................................................................................ 38
1.1 Excessive algae growth in water tank.................................................... 38
2 General......................................................................................................... 39
2.1 Mains switch “ON” - no function............................................................. 39
2.2 No display but circulation pumps run..................................................... 39
3 Drive ............................................................................................................. 39
3.1 Machine does not start automatically .................................................... 39
3.2 Machine doesn't stop automatically, motor and fan run continuously ... 39
3.3 Drive motor does not run ....................................................................... 39
3.4 Display shows error message “E2”........................................................39
4 Baths ............................................................................................................ 40
4.1 No circulation in developer or fixer baths...............................................40
4.2 Developer bath temperature is not reached .......................................... 40
4.3 Developer bath temperature is higher than the set temperature,
display shows two crossbars, developer temperature button blinks......38
4.4 Developer bath temperature too high or too low
(display shows values of 20 °C or 42 °C) .............................................. 38
4.5 Calibration of bath temperature / actual bath temperature is different
from displayed value.............................................................................. 38
5 Film defects ................................................................................................. 41
5.1 Films will not dry .................................................................................... 41
5.2 The film does not transport correctly ..................................................... 41
5.3 Scratches, pressure marks, dirt on film ................................................. 41
6 Replenishment ............................................................................................ 41
6.1 Replenishment pump does not work or works insufficiently .................. 41
7 Dryer.............................................................................................................41
7.1 Display shows error message “E4”........................................................41
7.2 Dryer ventilation does not function, no water inflow when water cock
opened...................................................................................................41
7.3 Dryer ventilation is too weak.................................................................. 42
7.4 Dryer temperature cannot be reached................................................... 42
7.5 Dryer temperature display exceeds the set value.................................. 42
7.6 Dryer temperature cannot be reached or is too high (display shows
values approx. 30 °C and 75 °C) ........................................................... 40
8 Water ............................................................................................................42
8.1 Rinsing water does not flow, ventilation runs......................................... 42
8.2 Water tank overflows ............................................................................. 42
1Algae
1.1 Excessive algae growth in water tank
Algae growth inside the water tank is not only anoying, it causes increased cleaning
work and leaves residue on the films. When algae growth increases, countermeas-
ures are in demand:
• When work has been completed at the end of the day, drain water out of the
machine.
• Clean dryer-water rack regularly. Use soft sponge and soap to remove resi-
due from the rollers.
• Install a particle filter system in the fresh water supply for the processor.
• If no other solutions can be found, then usage of Anti-Algae-Agents can be a
great improvement (automatic dispensers work the best). However, it is
known that cleaning agents containing chlorine may corrode rubber rollers
and high-grade steel in the tank area (check before use).