Photo Printer User Manual

4 COMPACT 2
TM
Technical Specifications
®
Technical Specifications
Film transport:
Continuous roller transport system
Film formats:
Sheet and roll films up to 45.1 cm (17.7 ) width;
Roll films with leader from 70 mm (2.8'') width;
smallest film format 10x10 cm (4x4''). In processor
type 1191 roll films in cassettes can also be proc-
essed. Cassette box (LxWxH): 53x19x16 cm
(20.6x7.5x6.3'').
Processing capactiy:
232 films 24x30 cm (10x12“) per hour (standard
model, film fed in crosswise, at 90 s)
Process time:
1-5 min.; in 0.1-min. steps adjustable.
Linear speed:
30-151 cm/min., depending on selected process
time.
Developing time:
14-71 s, depending on selected process time.
Tank capacities:
12.5 l developer, 12 l fixer,13 l water.
Circulation system:
Developer and fixer are continiuously circulated by
a circulation pump.
Replenishment:
Automatic by film surface measurement in relation
to processed film; quantity adjustable; time replen-
ishment can be activated.
Developer temperature:
Adjustable 28-40 °C (82.4-104 °F).
Fixer temperature:
Adjusted to developer temperature by heat
exchanger.
Dryer temperature:
Adjustable 35-70 °C (95-158°F), achievable tem-
perature depends on mains voltage..
Water connection:
Permissible water pressure 2 - 10 bar (29 - 145
psi), permissible water temperature 5 - 30 °C
(41 - 86 °F).
Water consumption:
1.9 litre per minute when processing.
Drain capacity:
11 litres per minute
Noise level:
Less than 59 dB(A).
Heat emission:
During processing approx. 1.5 kJ/s.
Environmental condi-
tions:
1 Temperature 18- 40 °C (51,6 - 104 °F), venti-
lated room, room temperature should be lower
than set bath temperature.
2 Relative humidity lower than 80 % up to 31 °C
(88 °F), linearly decreasing to 50 % at 40 °C
(104 °F)
3 Height above sea level less than 2000 m
(6666 ft.)
4 Indoor use