Photo Printer User Manual

42 COMPACT 2

Trouble Shooting

7.3 Dryer ventilation is too weak

• If the ventilation is connected incorrectly, it runs very slowly (heating element

in the air channel starts to glow).

Dryer ventilation connection:

7.4 Dryer temperature cannot be reached

• Check temperature sensor: Measure voltage at X24 on the power PCB

between pin 3 (green) and pin 2 (brown). The value should read 0.32 V at a

temperature of 32 °C.

• Only cold air flows from air channel: Heating element in air channel is defec-

tive. Disconnect X12 clip on the power PCB and measure resistance of heat-

ing element (approx. 26 Ω).

• Enter dryer temperature of 70 °C. Check voltage of X12 on power PCB. If no

voltage can be registered - exchange control unit.

7.5 Dryer temperature display exceeds the set value

• Check temperature sensor: Measure voltage at X24 on the power PCB

between pin 3 (green) and pin 2 (brown). The value should read 0.32 V at a

temperature of 32 °C.

• Enter dryer temperature of 35 °C. Check voltage of X12 on power PCB. If no

voltage can be registered - exchange control unit.

7.6 Dryer temperature cannot be reached or is too high

(display shows values approx. 30 °C and 75 °C)

• Check temperature sensor. Sensor is either not connected or defective.

8 Water

8.1 Rinsing water does not flow, ventilation runs

• Water pressure in the water system is too low: Minimum pressure 2 bar

(29 psi).

• Valve activates, no flow passage - filter at inflow is blocked.

• Check solenoid valve.

8.2 Water tank overflows

• Water drainage hose (overflow) should have a constant fall. The hose end

should be positioned above the drainage level in the syphon.›‹›

‹

• Check water drainage in the tank and hose for blockage and pollution.

• When extreme algae growth is noticed, the overflow can be connected

directly at the back of the water tank.

X9 L black

X9 Z brown

X10 N blue

X10 PE yellow / green