Photo Printer User Manual

COMPACT 2
TM
5
Technical Specifications
English
®
Safety Instructions
Pollution degree:
2
System protection:
IP 20
Electrical connections:
Type 119x-1
-y000:
Type 119x-2-y000:
Type 119x-7-y000:
220 - 240 V~, 10 A, 50 Hz
220 - 240 V~, 14 A, 60 Hz
208 - 240 V~, 14 A, 60 Hz
Unit tested to IEC 61010
(EN 61010, UL 3101, CSA 22.2-1010) overvoltage
category II 2.5 kW
Power consumption:
Stand-by: 0.23 kWh
Processing: 2.4 kWh
Weight (processor):
Empty 77 [91] kg
(170 [200] lbs)
Filled 115 [129] kg
(254 [284] lbs)
Values with open working table,
[in brackets: values with closed base cabinet]
Dimensions (LxWxH):
97 x 68 x 127 cm (38.2x26.8x50'')
Floor space required:
0.67 m
2
(7.2 sqft)
To ensure the safe operation of this processor, installation and use should
always conform to the instructions contained in this manual.
DThe developer and fixer chemicals used in the processor should be handled
according to the manufacturers instructions. In general: Non-diluted chemicals
are caustic. For this reason, chemicals should be handled very carefully. Avoid
contact with skin, always wear protective clothing, gloves and glasses when han-
dling the chemicals - for example, when mixing and refilling. Also when taking the
racks out for cleaning or servicing. In case of chemicals getting into the eyes,
rinse eyes immediately with cold, running water for approximately 15 minutes,
and contact a doctor afterwards. Inhalation of chemicals can be dangerous to
your health and should be avoided. For this reason, always ensure that the room
in which the processor is installed is adequately ventilated.
Environmental regulations regarding the storage and disposal of waste chemi-
cals should be obtained from the local water authorities and complied with.
Before opening the processor switch off the unit and unplug it from the electrical
socket. Service and repairs must be performed by trained service technicians
only. Use only manufacturers replacement parts.