Photo Printer User Manual

COMPACT 2
TM
57
COMPACT 2 NDT
English
®
Order No. 1193 - X - Y000
The Film Processor Compact 2 series was extended by a further version.
Introduction
Processing time and developer temperature of the Compact 2 NDT processor have
been adjusted to the requirements of NDT-films. This results in the following modi-
fications compared with the Compact 2 standard processor.
General
To maintain constantly good film quality the NDT-roller (upper roller of first roller
pair of fixer rack) has to be changed every 3 - 6 months, depending on the quantity
of films processed, the chemicals and films used. Three replacement rollers are de-
livered together with each machine. These rollers are subject to wear and tear and
therefore excluded from the warranty!
Technical Specifications (compare page 4)
Processing time (compare page 14)
Processing time from 2 - 10 min
Developer temperature (compare page 14)
Developer temperature from 26 - 40 °C
X: 1 50 Hz Y: 0 Open working table
260 Hz 7Closed base
Important!
Please take care that the film does not carry any dirt into the
processor.
Processing capactiy:
174 films 24x30 cm (crosswise), at lowest
processing time
Process time:
2 - 10 min
Linear speed:
15.5 - 76.5 cm/min
Developing time:
28 - 142 s
Developer temperature
26 - 40 °C
Processing and developer time relation
Processing time (min) Developer time (s) Infeed speed (cm/min)
2,0 28 76
2,5 35 61
3,0 42 51
3,5 49 45
4,0 57 38
4,5 64 34
5,0 71 31
5,5 77,5 28
6,0 84 25,5
6,5 91 24
7,0 98 22,5
7,5 106 21
8,0 114 19
8,5 121 18
9,0 128 17
9,5 135 16
10,0 142 15,5