Indoor Furnishings User Manual

Page 2
Congratulations! You have just purchased the best quality powerline carrier
lighting module available. X-10 PRO's Lighting Module is a high quality, X-10
compatible product that is a low cost alternative to hard-wired lighting systems.
This booklet covers all X-10 PRO models XP4LS and XP1LS.
CAUTION!!
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING DEVICE.
This device is intended for installation in accordance with the National Electric Code
and local regulations. It is recommended that a qualified electrician perform this
installation.
Retain these instructions for future reference.
To reduce the risk of overheating and possible damage to other equipment, do not
install dimming versions to control a receptacle, a motor-operated appliance, a
fluorescent lighting fixture, or a transformer-supplied appliance. This product is for
indoor use only. Connect only copper or copper clad wire to this device.
Pour re'duire le risque d'augmenter la chaleur des diffe'rents equipments, ne pas
installer une piece de control, une machine `a moteur, une fixture fluorescente or un
transformateur.
INSTALLATION
Installation Notes
a. Be sure that power to the supply circuit has been disconnected by removing fuse or
turning circuit breaker off. Installing the module with power on may expose you to
dangerous voltages and may damage the device.
Installation Procedures
1. Install a standard 4 gang box or RACO 953 box, pre-wire for power, loads, remote
switch, and transmitter controls.
2. Power should be a 20 circuit directly from a breaker 2x12ga wire and ground.
3. Load, remote switch, and transmitter circuits should each be connected via separate
sets of two 14ga wire with ground.
4. Using a voltage tester, identify and mark the “Hot” and the “Neutral” wires.
5. Identify and label each pair of load and control point wires.
6. If setting up an X-10 PRO lighting system enter the appropriate circuit labels and
addresses in the programming manual worksheets and on the module labels.
7. After all connections have been made, be certain all wire connectors are firmly
attached and there are no exposed wires (except the bare ground wire).
8. Place wires and insert into wall box and screw unit into place with supplied screws.
Four gang box uses four or eight 6x32x1/2 screws, Raco 953 box uses four
8x32x1/2 screws.