Operating instructions

Basic Operations
80
Chapter 4 Shooting
2 Launch the browser and input http://
<camcorder’s IP address>/rm.html in
the address bar.
Example: When the IP address is
192.168.1.10, input http://192.168.1.10/
rm.html in the address bar.
The Wi-Fi remote commander will appear on
the device screen when the Wi-Fi connection
is established.
Thereafter operate the camcorder as shown
on the screen of the Wi-Fi connected device.
The REC button becomes unavailable when
the Lock switch is dragged to the right.
Notes
• Depending on the device, the Wi-Fi remote
commander may not appear properly on the device’s
screen even though you input http://<camcorder’s IP
address>/rm.html in the address bar. In this case, input
“rms.html” for a smartphone or “rmt.html” for a tablet
at the end of the address to display the Wi-Fi remote
commander properly.
• The Wi-Fi remote commander on the device’s screen
may no longer match the actual status of the camcorder
in the following cases. When this happens, refresh the
browser on the device.
- when the camcorder is restarted while the Wi-Fi
connection is established
- when the camcorder is controlled directly while the
Wi-Fi connection is established
- when the device is reconnected
- when you operate forward/backward on the device’s
browser.
• If the Wi-Fi signal is poor, the Wi-Fi remote
commander may not work properly.
• Your smartphone/tablet may not be compatible with
the ad hoc mode. For details, refer to the operating
instructions supplied with the smartphone/tablet.
Compatible devices
The following devices, using the specified
versions or higher, can be used as Wi-Fi remote
commanders.
1 Attach a fully charged battery pack (see
page 29).
2 Load one or two SxS memory cards (see
page 58).
If you load two cards, the camcorder
switches automatically to the second card
when the first card becomes full.
3 Set the camcorder’s POWER switch
(see page 11) to ON.
4 Make the following settings.
Marker display: On (see page 113)
Iris: Auto (see page 50)
Zoom: Auto (see page 51)
Camera output: Select the picture currently
being shot (camera picture), and turn the
DCC function on (see page 15).
Timecode advance mode: F-RUN (Free
Run) or R-RUN (Rec Run) (see page 54)
Audio input channel selection: Auto (see
page 21)
5 Push the AUTO W/B BAL switch to the
BLACK side to adjust the black balance
(see page 45).
6 Select a filter according to the lighting
conditions, and adjust the white balance
(see page 46).
7 Point the camcorder at the subject, and
adjust the focus (see page 52) and zoom.
8 If you are using the electronic shutter,
select an appropriate shutter mode and
speed (see page 48).
9 Do one of the following to start
recording.
- Press the REC START button (see
page 13).
- Press the VTR button on the lens (see
page 24).
Device OS Browser
PC Windows 7 Internet Explorer
8 or Internet
Explorer 9
Mac OS 10.7.4 Safari 5.1.6
Smartphone Android 2.3.3 Standard browser
iOS 5.1.1 Safari
Tablet Android 4.0.3 Standard browser
iOS 5.1.1 Safari
Basic Operations