User manual

Simon XT
User Manual
24
Sensor open. This condition occurs if a door or window is open or a system sensor has been disturbed and
not reset properly. For example, a door/window sensor magnet may have been removed from the sensor.
Your system will indicate this condition to you by causing the STATUS button to light. When you press
the STATUS button, the display shows, for example, Sn 1 Front Door Open. Correct the problem by
resetting the sensor. If this condition continues, call your security system dealer.
Sensor tampered. This condition occurs when a sensor is physically tampered with, for example, the
cover is taken off of one of the sensors. If the system is armed an alarm will occur. Your system will
indicate this condition to you by causing the STATUS button to light. Trouble beeps will start. Press the
STATUS button and the display shows Sn # Name Tampered. Correct the problem by resetting the sensor.
If this condition continues, call your security system dealer.
RF jam detected. The panel receiver may be experiencing some interference. The system will call to
notify the central monitoring station about this problem.
Clearing status. Some types of status conditions, such as the alarm history, must be cleared manually. To
clear system status, press the STATUS button, read and/or listen to the status messages, then press
DISARM. If the trouble condition was a low system battery, perform a sensor test. The STATUS light
should turn off if all trouble conditions have been corrected.