User Manual

8
6.0 maIntEnancE, sErVIcInG, and storaGE
6.1 CLEANING: Cleaning procedures for the Rebel SRL are as follows:
• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so
excess water can drain out. Clean labels as required.
• Clean the Web Lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry
with heat. The lifeline should be dry before allowing it to retract into the housing. An excessive buildup
of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing causing a potential
free fall hazard.
Important: If the lifeline contacts acids or other caustic chemicals, remove the SRL from service and wash
with water and a mild soap solution. Inspect the SRL per Table 2 before returning to service.
6.2 SERVICE: Rebel SRLs listed within this instruction are not repairable. If the SRL has been subjected to fall force or
inspection reveals an unsafe or defective condition, remove the SRL from service, mark “UNUSABLE” and send to an
authorized service center for repair.
6.3 STORAGE AND TRANSPORT: Store and transport the SRL in a cool, dry, clean environment out of direct sunlight. Avoid
areas where chemical vapors may exist. Thoroughly inspect the SRL after any period of extended storage.
7.0 spEcIFIcatIons
7.1 PERFORMANCE: Your Rebel SRL has been tested and certied to the performance requirements of the standard(s)
identied on the cover of this instruction manual. See “Section 2.0 - Limitations & Requirements” for performance
specications.
7.2 MATERIALS: Material specications for the Rebel SRL are as follows:
Housing: Nylon, UV Resistant Motor Spring: Stainless Steel
Drum: Nylon, Type 6/6, Glass Filled Swivel: Zinc Plated Steel
Fasteners: Zinc Plated Steel Screws; Stainless
Steel Rivets
Lifeline: Polyester Web
Locking Pawls: Stainless Steel Energy Absorber Cover: PVC Tubing
Web: Polyester
Main Shaft: Stainless Steel
End
Connectors:
(See Figure 1)
Gate Opening Gate Strength
Steel Carabiner 11/16 in (17.5 mm) 3,600 lb (16 kN)
Steel Snap Hook 3/4 in (19 mm) 3,600 lb (16 kN)
Steel Swiveling Snap Hook 3/4 in (19 mm) 3,600 lb (16 kN)
Steel Rebar Hook 2 1/4 in (57 mm) 3,600 lb (16 kN)
7.3 LABELING: Figure 11 illustrates Rebel SRL labeling. All labels on the SRL must be present and fully legible.