Instructions

ManualsBrandsProtector ManualsBuilding TechnologyProtector Wireless discharged air control AS 7230 1000 W

distance between the two sections of the casing is

less than 6 mm when the window is closed. Use

the included packing (U) to adjust the parts for

this purpose.

• We recommend attaching the contact and the magnet

with the double-sided sticky tape before the ﬁnal

mounting and to only screw the elements in place at

the end.

Testing the function of the window tilt

and swivel position

• Slowly move the window to the tilt or swivel position,

then the green LED on the window transmitter (OPEN)

will ﬂash brieﬂy before the maximum tilt or

swivel position.

• Close the window, then the red LED (CLOSED) will

ﬂash brieﬂy.

• Finally check the opening gaps again using the

minimum value determined in accordance with Table 1.

Attaching the roller shutter transmitter

AS-R40 (ﬁgures 20 and 25)

NOTE

Attach the roller shutter transmitter and the magnet

to the window and the frame for the initial opera-

tion using double-sided sticky tape. Once the

function test has been completed then the roller

shutter transmitter and the magnet can be

screwed in place

Attaching the roller shutter transmitter

The roller shutter transmitter and the magnet must

be attached as shown in ﬁgure 4. The roller shutter

transmitter must be attached to the inside of the

window in the vicinity of the opened roller shutter.

Alternatively the transmitter may also be attached

between the window and the roller shutter but this

will weaken the radio signal. The attachment point

must be selected in such a way that a ‘roller shutter

open’ signal is only produced once the roller shutter

is completely open.

Proceed as follows to attach the roller

shutter transmitter:

1. Mount the lower casing section of the roller shutter

transmitter to the correct position using the included

double-sided sticky pad.

Alternatively there is a prepared hole in the lower casing

section to screw the roller shutter transmitter onto the

window frame. To use this carefully remove the printed

circuit board from the lower casing section and screw

the casing in place using the included screw. Then

carefully replace the printed circuit board.

2. Insert the battery (1x size CR2477) into the

transmitter with the correct polarity and ﬁx it in place.