User Manual

PREPARING THE STAND

See Figure 6

1. Lay the stand’s top surface down on the oor with the folded legs on top.

2. Press the Quick Release Leg Lock Lever and rotate that leg up until the locking pin

clicks into place.

3. Repeat with the remaining three legs.

4. Lift the stand and place it in an upright position.

5. Check to ensure the stand is stable and that all the legs have the locking pins engaged.

Washer

Spring Washer

Nut

ATTACHING THE AXLE PLATE

See Figure 4

1. Place (2) M8*20 bolts through the holes in the axle plate.

2. Place the axle plate onto the end of the miter saw stand making sure that the bolt

runs through the holes on the miter saw stand.

3. Place the washer and spring washer over each bolt on the back side of the miter

saw stand.

4. Lift the miter saw stand to an upright position.

5. Tighten M8 nut over the washer until secure.

ATTACHING THE PULL HANDLE

See Figure 5

1. Place (2) M8*20 bolts through the holes in the plastic handle.

2. Place the handle onto the end of the miter saw stand, and make sure the M8

bolts pass through the holes in the body.

3. Place a washer and spring washer over each bolt exposed on the backside of

the miter saw stand.

4. Lift the stand and place it in an upright position.

5. Tighten M8 nut over the washers until secure.

FIG 4

FIG 5

FIG 6

Spring Washer

Washer

Knob Nut M6

Bolt M8*20

Knob M8*25

Knob M8*35