User Manual

ATTACHING YOUR MITER SAW OR OTHER BENCH TOP POWER TOOL

See Figure 8

Various bench top tools can be used with your Contractor Miter Saw Work Station by attaching

them to the Rapid Clamp Tool Mounts. Always position the saw to achieve maximum balance and

stability. All four corners of the saw must be bolted to the tool mounts before use. Make sure

bolts do not extend above the table of the miter saw.

ASSEMBLING AND INSTALLING MATERIAL WORK SUPPORTS

See Figure 7

1. Slide a carriage bolt (M6 x 55mm) through the square hole in the work support and extend

through the other side.

2. Place the work stop over the end of the bolt.

3. Thread a knob nut M6 (Part #12) over the end of the bolt and tighten to secure.

4. Slide the work support rail through the hole in the top of the work support mounting bracket.

5. Insert knob M8*25 (Part #11) through the small hole on the side of the material support

receiver and tighten to secure.

6. Slide the material support receiver over the extension rail so that the extension rail extends

through the opening in the receiver. Position the work support at the desired location on the

extension rail.

7. Thread knob M8*35 (Part #10) into the hole in the bottom of the material support receiver and

tighten to secure.

8. There are two M8*35 knobs. They have slightly longer shafts than knobs M8*25. To use, insert

them into the crossbeams to adjust the length of the extension rail.

9. Repeat with the other supports.

FIG 7

Knob Nut M6

Material

Support

Receiver

Knob M8*25

Knob Nut M6

Knob M8*25

Knob M8*35

Extension Rail