User Manual

OFFSET MOUNTING

See Figure 9

Offset Mounting Bracket for Miter Saws and/or Power Tools with an irregular

mounting hole pattern.

Instructions: Secure offset mounting brackets as shown. Brackets can be used

on the front or rear of the Rapid Clamp Tool Mounts.

NOTE: If the saw has holes that do not line up with the slots in the tool

mounts, use the offset mounting brackets.

1. Unplug the saw and lock the saw arm in the down position.

2. Place a tool mount underneath the saw, aligning the mounting holes on the miter saw

base with the slot in the top of the tool mount.

3. Feed a carriage bolt up through both the tool mount and a mounting hole in the saw.

4. Secure in place using a at washer, spring washer, and nut.

5. Repeat through the other end of the tool mount.

6. Place the second tool mount underneath the other side of the saw, aligning the

mounting holes on the miter saw base with the opening in the tool mount.

7. Install carriage bolts as previously described.

8. After making sure both tool mounts are parallel to each other, nger tighten all four nuts

to hold in position.

FIG 8

FIG 9