User Manual

TO REMOVE SAW FROM STAND

See Figure 11

1. Raise the locking levers to unlock the saw and tool mounts.

2. Lift away from the rear rail of the stand to disengage.

3. With the assembly tilted slightly toward you, lift the assembly to disengage from

the front rail of the work station.

MOUNTING THE MITER SAW TO THE STAND

See Figure 10

Use the handles located at the rear of the tool mounts to aid in installing or

removing saw and tool mount assembly.

1. Lift the saw and tool mount assembly, allowing the assembly to tilt slightly

toward your body.

2. While still tilted toward you, hook the front edge of the tool mount assembly

onto the front rail of the stand.

3. Lower the tool mount assembly to allow the rear edge of the tool mount to seat

fully over the rear rail.

4. Lock the tool mounts in position by lowering the locking levers.

NOTE: Continue to hold the tool mount assembly with one hand until both

levers are securely locked.

5. Check position and adjust if necessary to make sure the weight of the saw is evenly

balanced over the rails.

6. Ensure the saw is seated and locked in position, then securely tighten the four nuts

holding the saw to the tool mounts.

FIG 11

FIG 10