User Manual

TRANSPORTING AND STORING
See Figure 12
1. Before storing or transporting, make sure all attachments are secure and bench top tool
is removed.
2. Collapse legs and make sure they are locked into the up position.
3. Use the handle that is located on the end of the product for transporting.
4. Pull up on the handle and tilt workstation until weight is distributed evenly onto wheels.
TOOL MOUNT ADJUSTMENT SCREW
Most plastic tool mounts are designed to t snugly over the stand rails. With the locking levers
in the lowered (locked) position, you should not be able to remove the saw and tool mount
assembly from the rails. If the saw and tool mount can be removed from the rails when the
levers are locked, the tool mount adjustment screws need to be tightened. If the saw and the
tool mount assembly will not t over both rails, the bracket adjustment screws needs to
be loosened.
NOTE: The saw should be removed from the tool mounts before attempting to
tighten or loosen the tool mount adjustment screws.
9
TO ADJUST
See Figure 13
1. Use a wrench to slightly loosen the nut.
2. Turn the screw with a Phillips screwdriver. Rotate clockwise if the tool mount assembly needs to be tightened or counterclockwise if the assembly
needs to be loosened.
3. Install the tool mount on the Contractor Miter Saw Work Station rails and lower the locking lever to check the adjustment.
4. When the correct position is achieved, tighten the nut with a 10mm open-ended wrench to secure.
5. Repeat steps 1 through 4 to attach the second tool mount.
FIG 12
FIG 13