Full Product Manual
Table Of Contents
- PRODUCT MANUAL Cover
- TABLE OF CONTENTS
- FEATURES AND SPECIFICATIONS
- PREPARING THE WORKSTATION
- INSTALLING THE TOOL HOLDERS / HANDLES
- ATTACHING SLIM PROFILE TOOL MOUNTS TO YOUR MITER SAW
- MOUNTING MITER SAW ASSEMBLY TO THE STAND
- REMOVING MITER SAW ASSEMBLY FROM THE STAND
- TRANSPORTING AND STORING THE WORKSTATION
- SAFETY AND WARNINGS
- GENERAL MAINTENANCE
- WARRANTY
FIND OUT MORE AT PROTOCOLEQUIPMENT.COM
I 1
ATTACHING SLIM PROFILE TOOL MOUNTS TO YOUR MITER SAW
3RD HOLE
1ST HOLE
3. FOR OVERHANG MOUNTING: Tool mounts are pre-installed for overhang mounting.
Stair steps should already be installed in first and third holes starting from tool mount
handle side.
4TH HOLE
2ND HOLE
4. FOR CENTER MOUNTING: Use 4 mm hex key to loosen screws and remove stair steps
from tool mount. Reinstall stair steps into second and fourth holes. Make sure stair steps
are facing away from tool mount handle. Repeat this step for the other tool mount.
O-RING
CARRIAGE BOLT
5. Feed two carriage bolts from underneath the tool mount, one bolt per slot.
6. Add a rubber O-ring to each carriage bolt.
10