Instructions for Use

2 CARACTERISTIQUES

This chapter describes all the features offered by your transmitter. It is important to familiarize yourself with each of

them in order to get the best in all circumstances.

Before entering in detail every feature of the transmitter, we suggest you familiarize yourself with the main screen of

your transmitter.

When powering up the transmitter, the display briefly shows the firmware version and then displays the main screen as

follows:

Access to Features menu is from the main screen of the transmitter. The main screen display is obtained after switching

on the transmitter.

Make it a habit to position the throttle stick at idle and up the TIMER switch before turning on the transmitter.

Also check the position of the other three inters before using the transmitter.

If the throttle stick is not positioned at idle switching on, an alarm sounds and the following warning message is

displayed:

The operation of the transmitter is disabled. Place the throttle stick at idle to allow the transmitter to continue its

initialization sequence and become fully operational.

If the TIMER switch is set down, the voltage of the battery is replaced on the screen by the time clock, indicating that it

will start counting when the throttle stick is moved.

Transmitter is operational as soon as the main screen changes and the connection is established with the receiver to

which it is paired (red LED is ON).

However you want to customize the settings of the transmitter to allow you to control in the best possible conditions

each of your models.

This is why we have provided this transmitter of a programming menu both simple and efficient. It can store up to 8

different configurations of models called model memory.

Each of these memories can store the main flight parameters as follows :

 The model name out of 4 characters

 The direction of travel of each of the 6 channel servo

normal

Reversed

 Ailerons, Elevator and Rudder Dual Rates throws.

 One of the 3 following mixes

 Flaps

 Delta

 V-tail

 Battery type and the corresponding low level alarm check

 4 NiMH

 1S LiPo

 2S LiPo

To enter the programming menu, press the ENTER key.

10 FUNCTIONS

Current memory

Tx battery level

Tx battery voltage

Throttle trim (mode 1)

Ailerons trim (mode 1)

Elevator trim (mode 1)

Rudder trim (mode 1)