Instructions / Assembly

Table Of Contents

C. 90° Corner Sections

1. Find the seam at the edge of an Radius 90° corner. Pry the

spacer apart into two pieces. ( 4” and 80mm )

a. Remove the barbed tabs from a half corner horizontal

spacer. (4” and 80mm only)

b. Place the spacer in the bottom of the opening, centered

under the Corner block location. There should be a 1/2”

gap between straight sections of the spacer and the

shaped spacer.

2. Place the half spacer, ﬂat side down, in the bottom of the open-

ing, centered under the AllBend

™

block location. There should

be a 1/2” tapered to a 1/4”gap between straight sections of

spacer and the shaped spacer.

2. Sharp 90° corner (4”, 80mm and MYMINIGLASS

™

only)

a. Cut standard spacers at 45°

b. Align spacers below block to create 90° corner.