User Manual

Pro Video Instruments

VeCOAX Compact RF Series Modulator Manual

NOTE: BEFORE INSTALLATION

Please test each unit UNMOUNTED ON A TEST BENCH with your Test TV before installing your units to

ensure you are receiving the Test Pattern signal. Then Program your unit. If installing Multiple units,

make sure each unit has its own frequency it's broadcasting on as well as it’s own Major/Minor.

This makes troubleshooting easier.

To test your unit, simply connect your TV with a short piece of Coax cable to the RF out of the Unit. No

HDMI needs to be connected for this test.

Scan for channels on the connected TV. Depending on your supported TV standards, scan for digital

channels.

After the scan is complete, you can tune to channel 1.1, and the test pattern will be visible.

By default, our unit is set to QAM (J.83B Cable) mode. This can be changed by referring to our QUICK

GUIDE below.

Please refer below for our QUICK GUIDE to setting up your device for your application and needs.

NOTE: IF YOUR TV TUNER HAS DIFFICULTY PICKING UP THE CHANNEL PLEASE REFER TO

OUR ADVANCED MENU -> MIXER MODE OPTION AS WELL AS ENSURING YOUR TV

STANDARD IS SET UP FOR YOUR TV TUNER’S SUPPORTED FORMAT, SUCH AS DIGITAL CABLE

OR DIGITAL ATSC. THIS MIXER MODE IS INCLUDED IN SOFTWARE VERSION VECOAX 2.37

AND ABOVE