User's Manual

16
Configure Channels 1 & 2
AUDIO PID = Id of the Audio Stream – do not change unless your application requires it
– default for the left column = 102 ( displays 0x when saved )
– default for the right column = 106 ( displays 0x when saved )
PCR PID = Id of the PCR stream – do not change unless your application requires it
– default for the left column = 101 ( displays 0x when saved )
– default for the right column = 105 ( displays 0x when saved )
VIDEO DOT = Dot is GREEN When a valid video is connected and the proper video input is selected
If the video dot is RED, check your source is set to output 59.94 frames per second
standard US Television format, test with a DVD Player or a Bluray disk player FIRST
DO NOT USE A COMPUTER AS VIDEO SOURCE AT FIRST as it might require
to configure the computer output to make it the same as the DVD or BlurayDisk to be compatible
to the TV OVER COAX MPEG Standard ( USA = 480i / 720p / 1080i @ 59.94 frames/s )
If the Video Dot switch between Green/Red Continuously, your video source is feeding
a wrong video format, Not Suitable for the Video Over Coax distribution.
Most likely it is 60 frames, and the US Over Coax Standard is 59.94
Please test with another source as a DVD to compare, then change the video source for a proper
valid output @ 59.94 frames. In case your source does not support the US Coax format standard
a little video adapter can be added on the video cable to adapt the video to standard US format
IF the video source works when connected directly ( hdmi or video ) to the tv, this is because
the tv is a slave monitor device when connected via video cable, different from when the tv
works receiving from the coax using its built-in coax MPEG Video receiver decoder
VIDEO FORMAT = When the Video Dot is Green, this displays the current video format from the input
BITRATE = When the Video Dot is Green, this displays the current TOTAL BITRATE for this channel