User's Manual

2
1) This unit is already pre-configured
Follow the quick start points on the next page to operate the unit plug n play
There is no need to reset the unit
If you reset the unit from the front panel, all settings will be lost, and you will need to set again
all the parameters as per this manual.
2) Models after June 2015 comes standard with a USB PEN Drive
with all the needed instructions, software, preset files. You can request a copy only via email to
[e-mail] specifying your version of HW and SW on top of the Welcome web
interface of your system
3) In case of need > Load the Default Configuration File to restore our best factory settings
In case of need, you can restore the Default Best Settings by loading the default configuration
file from your USB Memory > CONFIGURATIONS FILES FOLDER > default configuration.
From the computer WEB interface > BACKUP/LOAD > BROWSE the wanted configuration file
on the usb > LOAD. For the computer operation see the configuration via computer next on
this manual.
4) If you need to install MULTIPLE UNITS
these must be set to different frequencies, channels names & numbers to operate on the same
coax without conflicts.
Depending from the model there might be ready-to-go configuration files stored on your USB PEN to
configure units 1, 2, 3, 4, 5 …
From the computer WEB interface > BACKUP/LOAD > BROWSE the wanted configuration 1, 2, 3, 4,
5… file on the usb > LOAD. For the computer operation see the configuration via computer next on
this manual.
5) If you are looking for a specific configuration
just follow this manual, page by page, for each of your units.
At the end you can save your specific backup file for this configuration for future use
6) For tech support, the most rapid service is to send an EMAIL to [e-mail],
so we can respond to you Monday to Friday 9am – 4pm est with manuals, pictures, guides, and
rapid suggestions we cannot send you over the phone. Tech support via email usually replies in
minutes, very urgently. Email send Friday afternoon are replied Monday. All US National and FL
Holidays excluded.
Read Me First