User's Manual

21
Set the
Coax Frequencies
Set the Frequencies to use on the Distribution Coax
This modulator can output up to 4 different frequencies, usually one per each video input for the maximum quality
These 4 frequencies can be “ adjacent “ following the frequencies table at the end of this manual
When you select the first frequency to use, check on the frequencies table that the following 3 channels are following in
steps of 6 mhz
As example, using frequency 195 as first frequency ( CH 10 ) the following 3 frequencies will be
201 ( CH 11 ) 207 ( CH 12 ) 213 ( CH 13 )
In case of need, the used frequencies can be spanned each-other but must stay within a max window of 50 MHZ
The used frequencies on the coax are “ the carriers “ of the digital audio and video to the televisions.
To set the DESTINATION MEMORY POSITION / REMOTE CONTROL BUTTON on your TVs for each channel
you must use the VCT Virtual Channel Table setting, next on this manual.
As example, you might have free frequencies on your coax around frequency 133 and above, but you want these
channels to be listed on your tvs as 1 2 3 4..
The VCT makes this possible, so the physical used frequencies on the coax, and the destination memory positions
on your tvs are independent.
The VCT also allows you the set the SHORT NAME which are the CALL LETTERS that pop-up on your tv screens
when you switch the channels
On the web interface select MODULATOR to control the coax frequencies
Copy the values and selections as on the picture for a perfect operation