User's Manual

QUICK START HERE

1) Connect your Video Sources > Front panel Led CH1 CH2 CH3 CH4 turns on

This process is automatic, and there is no setting when you use HDMI or SDI

If you want to use other inputs you need to configure the video input first from the web interface

as described next on this manual

If one of the inputs is not valid or not connected, the ALARM led under the CH1 will turn on

The alarm led is one, for all the inputs, and turns on when one input is not valid

For your first test use a DVD or BLURAY or APPLE TV device

Do not use a computer for the first test as its video card might require additional configurations to

make it the same format as the dvd or bluray ( 720p / 1080i / 1080p @ 59.94 frames per second USA

TV Standard )

If you are using a computer out and the channel led on our front panel does not turn on, it means the video

format from the computer is wrong, not acceptable to run over coax to the TV Antenna mpeg decoder, so

you need to do a test with another type of source first, and then make the computer out the same as the

working source as per the specs above

FOR DIRECT TV BOX Connection :

1) SETTINGS>DISPLAY>VIDEO > native=ON / SCREEN= original

2) SETTINGS>DISPLAY>TV RESOLUTION > select 1080i and 1080p ONLY

all other resolution checkbox must be UNSELECTED

note: if your TVs are not FULL HD 1080, then you must select 720p

so the distribution will be in 720p only and your 720p TVs will decode it

2) Connect a first test TV with a short piece of coax cable, then scan for the channels

The found frequencies will show the channels on position 1 2 3 4 on the TV channel list

IMPORTANT : Make sure your TV ANTENNA MODE is set to CABLE QAM, and when you scan for the

channels you scan selecting STD mode scan ( available on some TVs )

IMPORTANT : If your TV is not receiving the channels, please test with another brand/model of TV as

Panasonic, Samsung, LG, Sony, Sharp, just to compare, as there might be some other settings on

the current tv that needs to be changed first.

3) After the above test is ok, you can connect the unit to your coax distribution and scan all the TVs to

find the channels

IMPORTANT : if you are not receiving the signal on the other TVs, please use the same first test TV

which was perfectly working, and move it step by step to the various locations through the coax, to

find where the signal stops.

There could be too much loss of signal on the coax, so you need to add a line amplifier, or there

could be a signal amplifier which is distorting the signal as our output might be too high and needs

to be lowered from the modulator web control page