User's Manual

39
IPTV Streaming out
OUTPUT SPTS 3 = Set the MULTICAST ADDRESS and Port and type of protocol for the IP Stream from the third
channel encoder
Default = 224.2.2.2 port 1003 protocol RTP/RTSP
OUTPUT SPTS 4 = Set the MULTICAST ADDRESS and Port and type of protocol for the IP Stream from the fourth
channel encoder
Default = 224.2.2.2 port 1004 protocol RTP/RTSP
OUTPUT MPTS = Set the MULTICAST ADDRESS and Port and type of protocol for the IP Stream
from the “E” Multiplexed ASI out
Default = 224.2.2.2 port 1000 protocol RTP/RTSP
SERVICE IP = The base address on the network for the IPTV RJ45 port.
Must match the address class of your network switch routing table if any
Default = 192.168.3.137
IMPORTANT : This address MUST BE different from the Remote Control port address.
As example, if this address is set to 192.168.3.xxx, the Remote control port Cannot be 192.168.3.xxx
and must be any number but 3
SUBNET MASK = The subnet mask for the network
Default = 255.255.255.0
GATEWAY = The address of the switch router
Default = 192.168.3.1
Click APPLY to set the changes