User's Manual

Pro Video Instruments

VeCOAX Ultra RF Series user Manual

ATSC (OVER THE AIR CHANNEL)

These are the Defaults and Good

starting point for PLUG N PLAY

setup.

If you have more than one unit

please ensure you change the

FREQUENCY, MAJOR/MINOR, and

SHORT NAME so they don’t

overlap and create issues.

With the above default, the unit

outputs on 473 MHz as channel 1.1.

• SOURCE – Set your Video Source HDMI, CVBS, or SDI

depending on your model

• STANDARD – Set your TV standard depending on

your needs, location, and support format of your TV.

• FREQ – Set your Frequency using our ATSC

Frequency chart on page 49. TVs will scan for the

Frequency, then store the channel as the

Major/Minor channel number you have set on the

Unit.

• VID QUALITY – Set the Latency Mode of your Video.

• MAJOR CHANNEL – This is the Major channel

number that will be displayed and stored in the TV’s

Virtual Channel Table (VCT). (For example, for

channel “10.1”, “10” is the Major channel number.)

• MINOR CHANNEL – This is the Major channel

number that will be displayed and stored in the TV’s

Virtual Channel Table (VCT). (For example, for

channel “10.2”, “2” is the Minor channel number.) If

you wish to have many channels with the same

Major number, use the Minor number to

differentiate.

• SHORT NAME – Name of the Channel you wish to

use. 4-6 Characters max depending on TV.

• AUDIO FORMAT – Set your desired Audio Format.

AC3 is the Default Standard for ATSC and QAM

mode.

• ADVANCED – Advanced options for users who

require Specific PID’s or Fixed EDID information.

Please don’t change these unless you understand

your required PIDs or EDID per Cable Provider

instructions or PVI Tech Support request.