User's Manual

Pro Video Instruments
VeCOAX Ultra RF Series user Manual
18
VID QUALITY MODES
The Vid Quality modes on the unit determine the speed and size of information sent to your TV’s
tuner decoder. The default is LOW LATENCY. DO NOT change this setting unless you are experiencing
issues with video quality. Using the other options available such as HIGH or Average will only change
the speed the information is given to the TV to be able to decode the picture properly (For slower
Television tuners and models)
LOW LATENCY - This mode is the fastest in terms of information sent to the TV. It sends frame by
frame which will give you the best picture and ultra-low delay for applications that require constant
use of the HDMI Source menu system such as Cable provider boxes or DVD players.
AVERAGE – This is a good balance between lower latency and speed of information sent to your TV’s
tuner. This mode sends the Information in smaller chunks rather than instant refresh rate which helps
with slower TV tuners that have slower/smaller decoder memory. This form of chucks can help give a
very slight increase in image quality due to the Tuner having time to decode each picture at its own
pace.
HIGH - This mode sends the Information in Lager chunks than Average mode which again can help
with slower TV tuners that have slower/smaller decoder memory. This form of chucks can help give a
very slight increase in image quality due to the Tuner having more time to decode each picture at its
own pace before the next set of chunks are received.
Note: A higher delay will occur with these modes due to the delivery of the information to the tuner
in form of chucks rather than picture by picture.